PCA9698
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 3 — 3 August 2010
20 of 48
NXP Semiconductors
PCA9698
40-bit Fm+ I2C-bus advanced I/O port with RESET, OE and INT
7.12 Output enable input (OE)
The configurable active LOW or active HIGH output enable pin allows to enable or disable
all the I/Os at the same time.
When a LOW level is applied to the OE pin, with OEPOL = 0 (register 2Ah, bit 4) or a
HIGH level is applied to the OE pin, with OEPOL = 1 (register 2Ah, bit 0), all the I/Os
configured as outputs are enabled and the logic value programmed in their respective
OP registers is applied to the pins.
When a HIGH level is applied to the OE pin, with OEPOL = 0 (register 2Ah, bit 0) or a
LOW level is applied to the OE pin, with OEPOL = 1 (register 2Ah, bit 0), all the I/Os
configured as outputs are 3-stated.
For applications requiring LED blinking with brightness control, this pin can be used to
control the brightness by applying a high frequency PWM signal on the OE pin. LEDs can
be blinked using the Output Port registers and can be dimmed using the PWM signal on
the OE pin thus controlling the brightness by adjusting the duty cycle.
Default is OEPOL = 0, so if the OE pin is held HIGH, the outputs are disabled. The OE pin
needs to be pulled LOW or OEPOL changed to ‘1’ to enable the outputs.
It is recommended to define the required polarity of the OE input by programing the value
of OEPOL before programming the configuration registers (IOC register).
7.13 Live insertion
The PCA9698 is fully specified for live-insertion applications using IOFF, power-up
3-states, robust state machine, and 50 ns noise filter. The IOFF circuitry disables the
outputs, preventing damaging current backflow through the device when it is powered
down. The power-up 3-states circuitry places the outputs in the high-impedance state
during power-up and power-down, which prevents driver conflict and bus contention.
The robust state machine does not respond until it sees a valid START condition and the
50 ns noise filter will filter out any insertion glitches. The PCA9698 will not cause
corruption of active data on the bus nor will the device be damaged or cause damage to
devices already on the bus when similar featured devices are being used.
7.14 Standby
The PCA9698 goes into standby when the I2C-bus is idle. Standby supply current is lower
than 1.0
μA (typical).
相关PDF资料
PIC16F74-I/P IC MCU FLASH 4KX14 A/D 40DIP
ATMEGA165-16AI IC AVR MCU 16K 16MHZ 64TQFP
ATMEGA165-16AU IC AVR MCU 16K 16MHZ 64TQFP
ATMEGA165V-8MU IC AVR MCU 16K 8MHZ 64-QFN
ATMEGA165-16MU IC AVR MCU 16K 16MHZ 64-QFN
ATMEGA165V-8AU IC AVR MCU 16K 8MHZ 64TQFP
AT91M55800A-33CI SL383 IC ARM MCU 16BIT 176BGA
AT91M42800A-33CI SL383 IC ARM MCU 16BIT 144BGA
相关代理商/技术参数
ATmega325V-8MU 功能描述:8位微控制器 -MCU AVR 32K FLASH 1K EE 2K SRAM ADC 1.8V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA325V-8MUR 功能描述:8位微控制器 -MCU AVR 32K FLSH 2K SRAM 1KB EE-8MHz IND,1.8V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA328 制造商:Arduino 功能描述:Atmel Atmega328 MCU w/Arduino bootloader
ATMEGA328-AU 功能描述:8位微控制器 -MCU AVR 32K FLSH 1K EE2K SRAM-20MHz IND RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA328-AUR 功能描述:8位微控制器 -MCU AVR 32K FLSH 1K EE2K SRAM-20MHz IND RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA328-MMH 功能描述:8位微控制器 -MCU AVR 16KB FL 512B EE 1KB SRAM 20 MHZ GRN RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA328-MMHR 功能描述:8位微控制器 -MCU AVR 16KB FL 512B EE 1KB SRAM 20 MHZ GRN RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA328-MU 功能描述:8位微控制器 -MCU AVR 32K FLSH 1K EE2K SRAM-20MHz IND RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT